Information on Install

Installation

1. Make sure there are no other programs running (CTRL + ALT + DEL, Explorer and Systray are the only running programs required).

2. Insert installation CD.

3. If Setup does not start automatically, click Start/Run, type X:Setup.exe (where X is your CD-ROM drive) and click OK.

4. Click Next at the welcome screen.

5. Click "Yes" at Software License Agreement (SLA) - only if you agree.

6. After Setup copies files to your computer and configures it for use with the SmartHub (which may take a few minutes on some slower computers, even appearing to "hang" for a few seconds - do NOT interrupt the setup), leave "Yes, I want to restart my computer now" selected on the Setup Complete screen and click Finish.

Connecting (Method 1 - recommended)

1. Click Start/Programs/SmartHub/Connect to SmartHub Network.

2. Select an ISP to use in the "Dial-up" box (first time only).

3. Enter your user ID/password and click "Connect". Do not check "Save password" or change any other information on the Extranet Access Client screen!

4. If prompted to do so, click "Yes" to save changes to current connection.

5. After clicking Connect, you may be prompted for your ISP ID/password. Enter this information and click Connect.

6. Click OK at the Security Banner, then OK again at the "Extranet Connection Established" screen.

7. At this point, you are successfully connected to the SmartHub network! If prompted to do so, you may cancel any attempts to connect to any networks or domains.

Connecting (Method 2)

1. Connect to the Internet using your usual ISP.

2. Click Start/Programs/SmartHub/Connect to SmartHub Network.

3. Enter your user ID/password and click "Connect". Do not check "Save password" or change any other information on the Extranet Access Client screen!

4. If prompted to do so, click